英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字，中文词皆可：

安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • Bowsprit replacement? - SailNet Community
    My bowsprit is laminated with nine pieces, approximately 2 8” square, to form an 8” square The outside Stbd three of these are totally rotted for about 12” long The inner pieces are rotted only two laminations deep, about 17” long The bottom piece still being sound
  • Retractable Bowsprit DIY - SailNet Community
    This is a copy of a post I made on the Catalina owners forum 1978 C27 std rig In the interest of flying my Gennaker or even getting a Code Zero furler some day, I'm fashioning my own retractable Bowsprit out of a scavenged Hobie Cat 16 boom extrusion that I had laying around, (A nice ridgid
  • Pros Cons of Bowsprit? - SailNet Community
    In an earlier post by Jeff H, whose opinions I respect, he said the following: "I also personally think that primary headsails tacked to the end of a bowsprit have no place offshore That would be a deal killer for me " Other than the obvious slip consideration, what do others feel are the
  • Bowsprit Anyone?? | EY. o Information Exchange
    A bowsprit will significantly enhance the performance of the sail by reducing the blanket effect of the main The longer the sprit, the less of an effect your main will have on your chute's performance More speed brings the apparent wind forward allowing you to sail a bit deeper (better VMG) By the way I like the graphic on the sail
  • Replace bobstay or dolphin striker. | SailNet Community
    A dolphin striker acts like spreaders on a mast to steepen the angle at which the bobstay meets the bowsprit, thereby increasing the downward force relative to horizontal force
  • DIY Bowsprit - SailNet Community
    I have been thinking of adding a bowsprit to my J24 Not to use for racing, just for the light air cruising days I would fly a genaker Could a retrofit kit damage the bow with unsupported upward forces? Would the tack of the standard 150 genoa chaff on the pole attached to the deck? Is it
  • Tensioning a Bobstay - SailNet Community
    The problem with just adjusting the forestay is that you can be pulling the bowsprit out of the deck due to large forces and lots of leverage Similarly, if you over tighten the bobstay, you can do the opposite, pulling the aft end of the bowsprit out of the Sampson post
  • TY 37 bowsprit drawing - SailNet Community
    The Ty37 bowsprit is easy to rebuild as a DIY project The strakes are alternating teak and 'an unknown asian softwood' The rot is usually only in the 'softwood' and once disassembled and cross-bolts removed the bowsprit laminations will easily come apart with a few blows with a mallet (and chisel) to break loose the poor polyester 'glue'
  • Catalina 30 - tall rig bow sprit, or standard? - SailNet Community
    Hi, I'm debating between a tall rig bow sprit C30 (Mark I) and a standard rig (Mark I) I sail in Boston, would primarily daysail, occasional 3 or 4 day cruise to the Cape or Maine Don't plan to race I think I would prefer the tall rig bow sprit, but is it a deal breaker? Also, I am
  • Adding a Bowsprit - SailNet Community
    I found an article in a mag that showed mounting a bowsprit for asym spins on an anchor roller, by removing the roller and bolting on a bracket to accept





中文字典-英文字典  2005-2009