英文字典,中文字典,查询,解释,review.php


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       


安装中文字典英文字典辞典工具!

安装中文字典英文字典辞典工具!










  • Custom board shows Error and reset loop after sucessfull flashing
    Re: Custom board shows Error and reset loop after "sucessfull" flashing Postby Sprite » Tue Aug 29, 2023 12:36 am Googling that 'assert failed' seems to indicate you selected a larger amount of flash than your board has Can you check that?
  • ESP32-S3 continuous reboot after flashing larger firmware
    I’m facing a persistent reboot issue on one of my ESP32-S3 boards after flashing a larger firmware binary Here’s a breakdown of the problem: After flashing my project (which worked earlier), the board continuously reboots with: Backtrace points to invalid memory access—likely due to bad pointer or heap exhaustion
  • XIAO BLE nrf52840 requires reset after each flash - Seeed Forum
    Every time when I’m changing the code, after uploading it to the board it unplugs and then requires a reset (via double-click on the button on the board) This essentially means that I cannot communicate over the serial port, since after flashing the port closes and I need to reset it every time to continue working
  • STM32F4 Program Will Only Run After Pressing Reset Button
    I recently purchased a NUCLEO-F446RE board (an STM32F4 product) and one minor issue has been bugging me All the code I've written executes and works just fine, but they only work after pressing the reset button on the NUCLEO board
  • VS Code Debug Flash works once, then fails on second instantiation
    The problem, is that after I build and debug one time, any subsequent attempt to flash the HW (nrf9160 dk) results in the following error message (below) I have included the part of the log that shows the flash working the first time Applying pin reset -- runners nrfjprog: Board with serial number 960084282 flashed successfully
  • TC397 immediately in reset - unable to re-flash - Infineon
    My goal is testing watchdog MCU reset mechanism but this way occurred hard reset several time in very short period I use Infineon wdg and gpt driver with Tresos generated code Without debugger (Lauterbach) the board go to reset immediately
  • Flashing stm32 success but resetting the board shows old program
    Describe the bug On a stm32n6570-dk, I program the hello world application for the board with west, get the logs that it worked but when resetting the board, the old program (demonstration program for the board already present when purch
  • TMS320F28379D: Power-cycle required instead of manual reset after flashing
    When I flash my Launchpad with said chip (Program to flash) the program executes After pressing the reset button, the program does not run through A power cycle resolves the issue and leads to the expected behavior of the reset button This issue occurs with the "upp_ex1_sdr_tx"-Example program


















中文字典-英文字典  2005-2009