英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字，中文词皆可：


请选择你想看的字典辞典：
单词字典翻译
Bheer查看　Bheer　在百度字典中的解释百度英翻中〔查看〕
Bheer查看　Bheer　在Google字典中的解释Google英翻中〔查看〕
Bheer查看　Bheer　在Yahoo字典中的解释Yahoo英翻中〔查看〕

安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • What is the best method to patch a large hole (2-3 inches) in drywall?
    cut a rectangle of drywall about three inches larger than your damaged area in both dimensions score the back of the drywall one inch in from each edge break the drywall at the score line, and then remove the drywall from the paper trace the drywall portion of the patch onto the wall, over the damaged area
  • How can I fill a drywall hole in a corner?
    However, if you have some extra pieces of drywall around you can make your own patch I fnd it easiest to square off the hole with a utility knife or keyhole saw Then cut a piece of drywall to fit inside the cutout - it doesn't have to be perfect Then take a narrow piece of wood like a paint stirrer and cut the length slightly longer than the
  • How do I fix a hole in drywall? - Home Improvement Stack Exchange
    Medium holes - A fist size hole or bigger is harder Cleanup the hole area Then take one or more more pieces of strapping and attach to existing wall to serve as foundation for the replacement piece of drywall Cut replacement piece of drywall and fit to opening, attach to strapping installed previously
  • How to fix a large hole in drywall - Home Improvement Stack Exchange
    There are hole patch kits that can be purchased at most hardware stores If that's not an option (maybe the hole is too big?) you can take a small square of drywall that's bigger than the hole and hold it up over the hole, mark around the piece with a pencil and then cut the hole out to the outside of the line
  • Fixing 1inch hole surrounded by torn drywall paper using spackle
    Joint tape goes over the hole, not in it The right solution is to skim the hole to fill it, lay tape over the hole so it laps the undamaged drywall, and let that dry A deep patch may take more than a day Be sure to apply compound under the entire tape area, but it should be thin so as not to create humps I recommend paper tape rather than
  • Drilled holes too wide for drywall anchors- how to fix?
    Depending on what type of wall you have (drywall, plaster, masonry( you could try putting a piece of cardboard or break a wooden toothpick and wedge it in between the hole and the anchor or glue it to the anchor I've done it before and it keeps the anchor from spinning when you tighten the screw
  • Drywall surrounding vent no longer supports screws;
    Screws that normally fix the vent in place can't do their job anymore The drywall has crumbled to the point that the tapped hole for the screw lacks a boundary with the duct (Picture attached ) Perhaps: The cutout for the original vent larger than necessary, forcing the screws to be closer to the duct than is optimal?
  • drywall - How do I repair a curtain rod anchor that was ripped out of . . .
    There's several ways to fix this, depending on a few things The best thing to do is avoid drywall anchors, and screw directly into a stud If there's one close enough that it looks okay, you should do that You'll have to patch up these holes, which may be a bit of a pain to do with the textured walls, but it's doable
  • How can I fix a hole in my drywall around the corner bead?
    Damage was done to the drywall near the bullnose corner bead which created a hole and caused the area on and around the corner bead to crack The drywall behind the right side of the corner bead no longer firmly supports it within the damaged area
  • repair - How should I fix this drywall hole for my bathroom paper towel . . .
    A Kreg Mini Pocket Hole Jig is fairly cheap and comes in handy for a number of projects (I have written a comparison of Kreg Pocket Hole Jigs on my DIY blog if you're interested in buying a different model for other projects ) Drive a long drywall screw part way in the center of the face of the lumber so you have something to hold on to





中文字典-英文字典  2005-2009